Best Way to Hang an Andersen Hinged Patio Door
Hinged patio doors, which are also known as French doors, swing either in or out, rather than slide. These doors provide the same visibility as a full sliding glass door, in the convenience of a swinging door. Anderson Windows makes these patio doors in single, double and triple paned. These doors come with instructions from the manufacturing company.
INSTRUCTIONS
- Build a rough opening the appropriate size for the door. This opening needs to include a wood header across the door opening and wall studs placed appropriately. If materials for interior floor are thicker than 1 11/16 inch above the sub floor then you will need to add a shim or slim wood piece under the sill of the door. Make sure the bottom is level.
- Remove the protective covers from the door using either a larger screwdriver or small pry bar. Protect the finished areas of the door while prying the cover loose.
- Around the rough opening of the door, apply three 3/8-inch beads of caulk. Set the door on the sill outside of the house. Raise the door so as to fit into the rough opening and apply caulking at the corners to fit into place.
- Check the vertical of the door for the plumb. You need to check the plumb on both the left/right orientation and the in/out orientation. Use a carpenter's level to gauge plumb. Make adjustments to the left/right orientation as necessary by using shims between the opening and frame. Make adjustments to the in/out orientation as necessary by sliding the door within the opening.
- Fasten the door in place using 3-inch screws. These screws will come with the product and will match the hinge colors. Place the screws in the doorframe in the designated locations. Do not securely tighten the screws at this time.
- Remove spacer clips between the frame and door with a small pry bar. Be sure to protect the finish while removing the clips.
- Add the door hardware. Remove the 3-inch factory installed screws from the hinge location and then install the hinge with these screws. Fasten the latch and lock assembly using the included 1-inch screws.
- Check the door to make sure that it swings easily without obstructions.
- Tighten the partially tightened screws through the frame into the studs and header.
- Place trim covers over the screws.
- You are now ready to use your newly installed Anderson Patio Door.