Best Ways to Wire a Garage
If you have recently built a garage, or your garage just doesn't have enough outlets or lighting, you can wire it for electricity yourself. With the right tools, a little electrical know-how, the right supplies, and a weekend or two you can have new electrical wiring installed in your garage. One option to make the process easier and less time consuming is leaving the main panel connection up to a professional.
Before you begin you will need:
Tools:
- Screwdrivers
- Screw gun and bits
- Electrical tester
- 3/4" hole punch
- Conduit tubing cutter
- Ditch digger
- Electrical tape
- Electrical fish tape
Supplies:
- 1/0 electrical, three strand wire
- 50-amp/100-amp junction box
- 3/4" conduit, elbows and connectors
- Junction box
Safety:
- Gloves
- Knee Pads
- Safety goggles
- Turn off the power at the breaker box and put on safety goggles and other safety gear. Make sure that the power is off by using an electrical tester to check below the main feed line coming into the breaker box.
- Use a screwdriver or screw gun to remove the panel cover.
- Use a hole punch to make a 3/4" hole in the bottom of the main breaker panel cabinet.
- Use a connector to connect a piece of 3/4" conduit to the bottom of the main panel box.
- Cut an 18" section of conduit using the tubing cutter.
- Drill a 3/4" hole in the wall directly behind where you plan to place your junction box.
- Use a conduit connector to install a small junction box.
- Punch out a hole the same size and the same way as you did with the main panel box.
- Use drywall screws to attach the box to the wall. The screws should be drilled through the back of the box.
- Call your utility company to make sure that the area is safe for digging. You have to dig a trench to run the electrical conduit from the breaker box to the garage.
- Use a ditch digger to make a trench. It should be about two-foot deep and about a foot and a half wide.
- Connect a conduit elbow through the hole in the junction box, run that into the trench and then add another elbow.
- Run 3/4" conduit the length of the trench. Use connectors where needed.
- Install a 50 or 100-amp junction box on the wall of the garage. You may require the assistance of a professional for this step.
- Use drywall screws to mount the box on the wall.
- Place another 3/4" connector at the bottom of the box.
- Run a piece of conduit into the trench and connect the two sections with a 3/4" conduit elbow.
- Run a section of fish tape through the conduit, from one junction box to the other. Fish tape is a steel wire that will make it easier to pull wires through the conduit.
- Pull three strand wires to the end of the conduit, leaving the wire three feet past the junctions box on each side.
- Strip back the sheathing on the wire and connect each end to a junction box. Black wires go to the breaker, neutral wires are neutral, and ground wires connect to the ground bar.
- Drill holes into the studs located in your garage walls.
- Run circuits for electrical outlets and lights.
- Place any lines you would like to dedicated to specific heavy duty tools or appliances.
- Install plastic boxes in the locations of where you will be installing outlets and switches and nail them to the studs in the wall.
- Run conduit lines to the plastic boxes.