Previous Article

About Dishwasher Repair

Next Article

Home Dishwasher Repair

DIY Dishwasher Repair

Dishwashers are complicated machines that serve us extremely well until they stop working. The great news about a dishwasher is that in about 90 percent of all troubles you may have with one, you can find and fix the problem yourself without having to call a repairman.

There are three major things that commonly go wrong with dishwashers and those would be that it won’t start, it leaks and the dishes aren’t coming out clean. Let us address those one at a time.


Problem Number 1: Will not start.


Check the power supply to make certain it is on. If it is on, turn it off and try turning the motors fan blades. The blades should turn freely. If not, you should call in a repairman. If the blades are freely turning and the motor is making a humming noise you should also call a repairman.


Problem Number 2: The machine leaks or water pools on the floor.


Find the source of the leak. Nine times out of ten this will be due to a bad seal on the door or leaking hoses. Check them both with the machine running. If the gasket on the door is cracked or broken or a hose is loose these you can repair. Either replace the door seal or tighten the hose fitting. Sometimes you will get lucky with the seal and it may just have dirt or food stuck on it and you can remove it. If those two are not the problem it could be a stuck float switch. If they stick in the lower position they will cause the tub to overfill causing a leak. Check it and clean it while you are doing so. Check the door to make sure it is tight against the machine. Check to see if the latch is tight. It should keep the door closed but not so tight you could bend the handle shutting the door.


Problem Number 3: Your dishes aren’t getting clean.


First you should take off and clean the spray arm. Twirl the arm to make certain it has free movement. It comes off with a clockwise movement that is the opposite of normal screw off patterns. You may need needle nose pliers to get out what you may find in the spray arm assembly. Next you may need to clean the float switch and most likely should while you are in here anyway. It this switch gets junk in it the switch may become stuck in the raised position and that would prevent the tub from filling. When that happens the dishes won’t clean well. When the float is clean it will freely move up and down.