How To Repair a Jewelry Prong Set
If you own jewelry, chances are you have seen the prongs that hold gemstones in. The prongs in many cases are made of nothing more than thin wire. The reason for this is that it allows more of the gemstone to be seen. Unfortunately, this wire may become damaged or break. Learning to fix your own jewelry will save you money.
If you wish to repair or replace jewelry prongs, you will find that you need some basic soldering skills. The stones will first need to be removed and then you will solder a replacement prong into place. This will take practice on your part as you do not want to damage an expensive piece of jewelry while completing this repair.
Before you begin, gather some supplies. Many will need to be purchased specially as most homes do not keep these items on hand. Start by getting solder, soldering picks, flux and a torch. You will also need a wire cutter and/or a jewelry blade and saw. Needle files, tweezers and a clamp will be needed for the repair along with copper tongs and an acid pickle bath. Binding or third hand wire, pliers or tweezers, a paintbrush and 220-grit sandpaper should also be purchased. Now you are ready to begin the repairs.
- Gently pry the prongs back using the tweezers or pliers. This will allow you to access the gemstone. Carefully slide the tweezers or pliers under the stone and lift it out. Take care not to scratch the gem while doing so.
- Take a piece of wire and place it next to the prong to measure the length of the wire needed. Carefully cut this wire with the jewelry saw and blade or the wire cutters. For the best results, choose wire that is similar to the wire found in the broken prong.
- Using the needle files, file and shape both the prong to be replaced and the replacement wire. Follow up with the 220-grit sandpaper. Your goal is to have the prong and the replacement wire sit flush and appear as one piece.
- Insert the jewelry into the clamp to hold it in place. Secure the small piece of metal to be used for the replacement prong to the broken prong using the binding or third party wire. Make sure the two pieces are positioned exactly as you would like them to be soldered.
- Using the paintbrush, paint the broken prong and replacement piece with flux. Take the jewelry saw or wire cutter and remove a small piece of solder. With the tweezers, soldering picks or pliers, place the solder at the base of the prong on the inside.
- Heat the entire piece of jewelry. Make sure the piece is heated evenly throughout and continue to do so until the solder starts to melt. Draw the heat using the torch to fix the prong that is broken. If you concentrate the heat on the broken prong only or overheat it, the prong may melt.
- Repeat this process until all broken prongs are repaired.
- Cool the jewelry to room temperature before continuing.
- Use the copper tongs to place the jewelry that has been repaired into an acid pickle bath. This will remove any oxidation produced by the soldering process. Once this has been completed, you should remove the jewelry using the tongs and rinse thoroughly with water.
- Using the tweezers or pliers, carefully place the gemstone back in the setting. Ensure the stone is centered. Gently push the prongs over the stone to hold it securely. Check to ensure all prongs are in place and that the gemstone is not loose.
Your jewelry is now ready to wear again. If you find you run into any problems, it is best to seek the assistance of a jeweler. He or she is trained in repairs of this type and you don't want to unintentionally damage the stone or setting by making a mistake.