Previous Article

How to Replace a Wood Fence

Next Article

How To Replace an Acura CL Headlight Bulb

How To Replace an Aboveground Pool Liner

Aboveground pool liners can become damaged and torn due to many factors. Tree roots, rocks, sand shifts and sharp objects penetrating from inside of the pool can all cause damage to your pool liner. When damage and tears occur, the pool liner will need to be replaced to avoid leaks. Aboveground pool liners can easily be replaced without having to hire a professional.

Step 1: Drain all the water from the pool. To do this, place a submersible pump in the shallowest part of the pool. Turn the pump on and direct the end of the hose to a drain or street. The pump will drain almost all of the water. Once the water level goes below the pump, it will not drain anymore. Remove the pump from the pool. You may need to scoop the remaining water out with a cup or soak it up with towels.


Step 2: Use a screwdriver the remove the screws that hold the caps and rails in place. Set the nails, caps and rails aside. You will need to install these back on the pool once you have replaced the pool liner.


Step 3: Use a razor blade to cut a small slit in the pool liner. Be careful not to cut the walls of the pool. Start at the slit and peel back the pool liner. The liner may pull free easily, or it may rip and need to be removed in smaller pieces. Once you have removed the old liner, you can dispose of it.


Step 4: Check the area to make sure there are no sticks, rocks or other sharp objects where the new liner will be placed. If you find debris, remove it and try to make the area as clear and flat as possible. You may need to move the sand around to make the area flat and level. You may also need to purchase more sand to fill in gaps or uneven areas.


Step 5: Place the new liner in the center of the pool. Unfold it and bring each outward edge the walls of the pool. Use your hands to flatten out the center part of the pool liner and make your way of the walls one section at a time. You will need to smooth out as many wrinkles as possible.


Step 6: Place the caps and rails back onto the pool. Use a screwdriver to drive the screws through the rails and caps and into the pool walls. Fill the pool up with water and allow the new liner to settle into place for at least 24 hours before swimming.