How To Set Up an Intex Pool
A pool can be great for summertime fun activities. Intex pools now make it easy for almost anyone to enjoy a pool in their backyard. Intex offers pools in avariety of sizes and shapes to fit all different yards and budgets. Intex pool packages are available at most local discount retailers and are fairly easy to maintain.
Before Setting Up the Pool
- Open your pool package, and check that you have all parts listed in the pool manual.
- Locate a completely level surface in your yard to place the pool. A pool placed on an uneven surface is dangerous. So completely level any surface to keep the water balanced.
- Make sure you have a Gound Fault Circuit Interrupter (GFCI) electrical socket in which to hook the pump. This is very important because these types of sockets will prevent electrical shock in case of electrical malfunction with the pump. It should never be operated, unless it is connected to this socket.
- Furthermore, the pool should also be located near your garden hose for easier filling.
- Check with your local building department to see if a fence is required in your municipality for your pool.
- Remove any sharp objects where you are placing the pool to avoid puncturing the liner.
- Depending on the pool package you purchased, your pool may have a large plastic tarp ground cover included. If so, spread this out on the area where the pool is to be set.
Setting Up the Pool
- Unroll the pool liner on top of the tarp, right side up.
- Do not drag the pool to the location as the liner can be torn. Have someone help you carry the liner.
- Place the filter connector holes facing the area where the pump will be located.
- Plug the power cord on the pump into the Gound Fault Circuit Interrupter outlet to check it.
- Allow liner to lay in the sun to warm it.
- Lay out the pipe pieces from the pool package.
- Slide one of the long pipe pieces through the pockets located around the top of the pool.
- Next, insert one the three hole connection pieces into one end of the pole, which was inserted into the top pool pocket. Align the holes in both pipes and thread the connector pin to lock the pieces together.
- Continue the above procedure until all the pipes have been installed around the entire perimeter of the pool.
- Now slide through the safety belts on the exterior sidewall of the pool. Lock each piece into place on the bottom of the tri-connectors installed in the steps above.
- Put end caps on the legs. This will prevent the raw metal from ripping the ground cover tarp.
- Shake the pool to see if all it appears sturdy. Furthermore, check to see that all connections and pins are locked into their proper place.
- Check the filter holes and connect it to the pool as per the manufacturer's instructions.
- Use a garden hose to fill the pool.