Previous Article

How to Assemble an Intex 18' x 48" Easy Set Pool

Next Article

How to Asses Special Education Programs

How to Assemble an Invacare Hospital Bed

Invacare makes products for home use and commercial use.  The company is based out of Elyria, Ohio and is a major distributor of medical equipment in the United States. Some of the products Invacare produces include wheelchairs and hoyer lifts.  However, one of the company’s most well-known products is its fully automatic hospital beds.  The beds are quality and allow patients to get the care they deserve.   


  1. Put the head spring on its side.  Stretch the spring to a 90 degree angle away from the frame and let it stand on its own.

  2. Place the foot spring on its side and leave the top facing towards the bottom of the head spring.

  3. Put the mounting rivets on the top of the foot spring in the mounting locks that are on the bottom portion of the head spring.

  4. Take the bed frame and extend if.  Lay the frame flat on the ground.

  5. Put the head end on top of the head spring.

  6. Grab the head spring and lift it up.  Put the corner rivets in the corner locks of the head spring.

  7. Do steps five and six with the foot end and foot spring.

  8. Guide the foot end coupler in the direction of the motor and turn it clockwise to extend it.  Lock it in the gear box of the foot end.

  9. Take the head pull tube and extend it until the spring button is locked into the designated hole.

  10. Put the bolt of the pull tube in the arm of the head spring.  Then lock it in place using the hitch pin.

  11. Take the head spring and extend it 90 degrees away from the frame.  Attach the hooks at the bottom of the head spring to the top of the foot spring.

  12. Grab the drive shaft and extend it until the snap button is locked in the first hole.

  13. Put one end of the drive shaft in the gear box of the head end.  Put the other end on the gear box that is on the foot spring.