How to Attach a Gutter to the Fascia
If you are installing gutters for the very first time or replacing them because of damage, most homeowners can to the task themselves. The gutters should be attached to the fascia for the best support. The fascia is the vertical board that is attached to the ends of the rafters under the roofline. It is usually a 1 inch thick piece of wood.
- Place a ladder in a position that is safe so you can attach the gutters. The first piece of gutter should be 2 inches longer than the position it is going to be installed on so it will allow 1 inch of overlap. This overlap is also needed when you seal the gutter with caulking.
- Move the ladder to the higher end of the roof. Place the gutter so that it is sloped from one end to the other. This will allow water to flow towards the downspout. The rule of thumb is to allow 1 inch to 1 ¼ inch drop for every 10 feet of gutter.
- Mount the gutter brackets to the gutter so that they are even. There should be three to four brackets used for every 10 feet of gutter. This will make sure the gutter can hold the weight of water.
- Attach the gutters to the fascia. Begin screwing from the inside of the gutter. Screw all the way through the gutter into the fascia.
- Continue to move the ladder down the length of the roof to install the gutters. Place a screw at many points. A rule of thumb is to screw in a screw about every 2 feet on the gutter.
- Apply silicone caulking at the joints of the gutter. Using a small bead of the caulking should be sufficient to fill in the joints.