How to Build a Kitchen Island Countertop
Many people are finding out today that they just don’t have enough kitchen cabinet space. If you have room in your kitchen for an “island” it may be the way to solve that problem. It will increase your cabinet space and give you a place to work to boot.
Items Needed:
- Hammer and finishing nails
- Circular saw
- Drill with bits and a Phillips screw tip
- Router with a laminate router bit
- Electric miter saw
- Wood glue and a damp cloth
- 48 – ¾-inch dowels
- Sanding block and 60-grit sandpaper
- 1 ¼-inch drywall screws
- 2 ½-inch drywall screws
- Plastic laminate
- 1 5/8-inch oak flat mold
- ¾-inch plywood
- Measure to obtain the outside edge dimensions of the island at its top. Now using the ¾-inch plywood cut two pieces exactly the same size and allow for it to hang over the entire edge of the top by one inch (if your measurements were 30 by 60 inches your cut pieces will be 31 by 61 inches).
- Put the glue on one of the pieces and get a thorough coverage. Place the second piece on top of this one and secure it down with 1 ¼-inch screws. If you have any glue that got on anything wipe it off with the damp cloth.
- Place the two pieces of plywood over the cabinet making certain it is exactly in the center. You should have a one-inch overhang all the way around it.
- Drill pilot holes with a 1/8-inch drill bit. Measure so as not to drill into the cabinets’ fronts below. Secure the top down with the 2 ½-inch drywall screws.
- Cut your laminate large enough to hang over the plywood top you have in position. Apply contact cement on the under side and let it dry. Do the same thing to the plywood top. Once they have dried apply a second coat to each.
- When the cement gets “tacky” place the dowels horizontally on top. They will keep the laminate from touching the plywood top until you have it in place.
- Place the laminate face down on the dowels. Make certain it is hanging over the edges of the plywood on all sides and remove the dowels one at a time while pressing the laminate against the plywood top.
- Once in place use the router and remove the overhang of laminate with the cutting bit. Clean excess cement and dirt with the soft wet cloth. Sand all edges with the sanding block and 60-grit sandpaper until smooth.
- Measure and cut the oak flat mold to fit around the perimeter of the top. Use your miter saw and cut a right 45-degree angle on one end and then a left angle on the other end.
- Apply glue to the back of the molding and secure it to the edge of the countertop with your finishing nails. Make sure your molding is even with the top of the countertop.