Previous Article

How to Build a Picket Fence With an Entry Gate

Next Article

How to Build a Playground

How to Build a Pickup Truck Topper

Not everyone has room in their garage to park their pickup truck. A pickup truck topper is perfect to keep things in your truck safe from thieves. It can also protect the truck from the elements. This article will instruct you on how to build a pickup truck topper.

How To Build A Pickup Truck Topper




  1. You will need a tape measure, 1-inch PVC pipe, marker, hacksaw, four 1-inch PVC 3-way connector fittings, two 1-inch PVC 4-way connector fittings, rope, stakes, tarp, scissors, and a snap clamp.


  2. Measure the length, width, and height of the pickup truck. Add an extra 3 feet to each dimension.


  3. Measure and cut out the PVC pipes. There should be six pipes cut to the height of the truck and three pipes cut to the width of the truck. There should be four pipes for the sides. Divide the length measurements in half and cut two pipes for each side to get the four pipes for the sides. Use a hacksaw to cut the pipes.


  4. Cut the tarp to size so that it covers the entire top of the canopy and extend it an extra give inches on each side.


  5. Lay out the pipes in the correct positions. The 3-way fittings should be placed at the corners and the 4-way fittings go between the pipes along the side. Connect the 3-way fittings to four of the legs posts. Insert a side pipe into the open end of the 3-way fitting.


  6. Attach the 4-way fitting to the other end of the side pipe. One of the right angle openings should face downward
    while the other face towards the opposite side of the canopy. Place the side pipe from the other half of the canopy frame into the other side of the fitting.


  7. The two remaining posts should be inserted into the downward face opening of the 4-way fittings. The final post go into the inward facing openings of the 4-way fitting.


  8. Cut four lengths of rope. The rope should be long enough to angle away from the frame at a 45-degree angle. Tie the rope to each of the four side pipes.


  9. Tie the end of the rope to the metal stakes and place the topper over the canopy frame. Secure the topper to the frame using clamps.