Previous Article

How to Build a Modular Storage Cube

Next Article

How to Build a Wall Display Shelf

How to Build a Shelf into an Alcove

An alcove makes a great feature to any home, and can be used to store small items, such as books, or electronic equipment. The alcove is easy to set up with just a few items and will provide tons of storage space for your home. This is an easy do-it-yourself home project.

Items Needed:



  • Awl

  • Jigsaw

  • Sliding Bevel

  • Screws and wall anchors

  • Drill

  • Lumber

  • Cleats

  • Wood Saw

  • Tape Measure

  • Level



  1. Put a cleat across the side of the alcove. Trim one end to make a 45 degree angle. Cut the length to fit behind the alcove. Doing this ensure the alcove will look pretty in the front.

  2. Drill a hole through the cleat. The hole should be one-third and two thirds across. Put the cleat up near the alcove and use the level to make sure it is straight. Use a writing utensil to create a line at the top of the cleat to mark the drill holes.

  3. Take the drill and drill holes in the wall where you marked. Using a hammer tap the anchors into place and put the cleat into place by screwing it.

  4. Measure the shelf to fit into the alcove perfectly. Slowly lower the shelf onto the cleat and hold it in place. Take the level and put it on top of the shelf to ensure it is level and draw a line with the writing utensil under the shelf.

  5. Put the rest of the cleats into position by drilling into the wall and then later screwing them in. Put the shelf into the alcove and add the items you wish to add to the alcove.