Previous Article

How to Buy Sand for a Child's Sandbox

Next Article

How to Choose a Jungle Gym

How to Cement in a Swingset

Swing sets generally come with pole anchors to secure them into the ground. However, these can fail and cause the swing to tip over. The easiest way to overcome this problem is by setting the posts with cement. This can be done easily with a few simply supplies and tools.

Supplies



  • Post hole digger or shovel

  • Concrete mix

  • Water

  • Trowel

  • Wheelbarrow

  • Gravel

  • Sand

  • Level

  • Construction paint


 



  1. Decide where the swing set will be placed and mark the ground where the posts are going to be installed with the construction paint.

  2. Dig a hole that is a minimum of one-foot in diameter and at least two-feet deep. Employ the post hole digger for this, or use a shovel.

  3. Fill the hole with two to three-inches of gravel at the bottom to provide for drainage.

  4. Set the swing set post into the hole.

  5. Check the placement with your level to make sure it is even.

  6. Combine one part cement mix with two parts sand and three parts gravel in the wheelbarrow. Add water to the mixture until it becomes a thick consistency.

  7. Scoop the concrete into each hole with the trowel. Push the concrete down with the end of a two-by-four to remove any air bubbles that may have formed.

  8. Pile the concrete up in a small mound around the base of each of the posts. This allows water to run off rather than pool around the base.

  9. Allow the concrete to dry for at least 48 hours before using the swing set.