How to Control Mold in Front Loading Washers
Washers that are front loading have a high efficiency level. The only problem that many people have with them is the mold that grows on them and gets on the clothes. The mold usually grows because the washer becomes damp and is sealed when you close it after washing a load. This is a breeding ground for mold spores.
How to Control Mold in Front Loading Washers
- Make sure you use a detergent that is made for front loading washers. They do not create a lot of suds that can get into the cracks and crevices of the washer and cause mold.
- If you do use regular detergent, do not use too much. Cut the amount you usually use by ¼ cup. The only problem with this is that the clothes will not be as clean but harmful mold will not grow.
- The solution to using regular detergent is to add ¼ cup vinegar to the laundry. The vinegar will reduce the amount of suds, which can be a problem when it comes to mold.
- Bleach is very good at controlling mold on a front-loading washer. Use bleach at least once a week when washing clothes to help control mold.
- Wash the door of the washer with equal parts of bleach and water every two weeks to control mold. After you clean the washer with the solution dry the door with a clean and dry towel. Make sure you wash and dry the seal around the door also.
- Allow the door to remain open for a while after you wash a load of laundry. This will dry the washer and prevent mold from growing.