Previous Article

How to Crackle an Acrylic Paint Finish

Next Article

How to Create a Bathroom in an Attic

How to Crank a Plumbing Snake

If you have a clogged drain that you have tried to dislodge yourself and all other methods have failed, you will have to take the next step. It is time to try the plumbing snake, or drain auger as it is sometimes referred. Drain snakes are not difficult to operate. They look more complex than they really are.

Supplies:



  • Drain snake

  • Rubber gloves

  • Trash bag

  • Plunger

  • Bucket


 


1. Examine the drain you need to unstop. Use the straightest route into the pipe, whenever possible, to reach the clog. The snake will be easier to operate and more effective, without having to pass through several bends in your piping to reach the clog.


2. Put on your rubber gloves.


3. Bail out any standing water in your fixtures with your bucket. In the case of a toilet, use a plunger to lower the water level.


4. Remove any drain stoppers, which may block the snake's entrance into the drain.


5. Turn the set screw on the snake and pull out three to four feet of the flexible steel cable.


6. Run the end of the auger which resembles a corkscrew into the drain pipe.


7. Continue pulling additional cable from your snake, as you push it further into the pipe.


8. When you are no longer able to push the snake any further into the drain, it is time to get cranking.


9. Tighten the set screw on the auger to stabilize the steel cable.


10. Crank the hand crank on the auger in a clockwise rotation into the clog. Keep releasing the set screw on the auger housing, allowing more of the cable as you crank to advance down the pipe.


11. Continue to do this until the snake advances easily down the pipe. The debris from the clog should be trapped on the corkscrew device on the end of the snake.


12. Remove the snake from the drain, by cranking in a counter clockwise rotation back into its housing.


13. Wipe the snake with a paper towel, as you advance it out of the drain.


14. Remove the debris from the corkscrew end and discard.


15. Replace any drain stoppers.