How to Design a Garden Cart
A garden cart is a very useful tool for the avid gardener. It can eliminate the amount of trips needed from the shed to the garden, and can carry all of the garden tools as well as any plants or dirt that might be needed for any project in the garden. Making one is easy to do for the do-it-yourselfer.
Things you’ll need:
- Screw gun
- Box of coated deck screws
- 4 wheels
- 4 carriage bolts
- Wood finish
- Paint brush
- 4 washers
- 4 boards, two-by-ten (two measure 36 inches long and two measure 18 inches long)
- Plywood panel 24 inches by 48 inches
- Create a box using the four two-by-ten inch boards. The 36 inch long boards are the sides of the box and the 18 inch long boards are the ends.
- Screw four of the deck screws into each corner of the side panels. There will be a total of 16 screws once they are all screwed in.
- Cut the plywood to a new measurement of 21 inches by 36 inches. This is the bottom of the garden cart.
- Place the plywood onto the bottom of the box that was created earlier. Make sure that it is flush all the way around. Use the deck screws and start screwing the bottom on. Distance the screws about 6 inches apart.
- Place wheels on each corner of the cart. Part of the wheel will hang down past the bottom of the cart. Place the washer over the carriage bolt and the carriage bolt through the hole in the wheel. Secure the carriage bolts in place to the cart.
- Place a wagon handle on one of the ends of the wagon. Follow the manufacturer instructions for installation and the provided hardware.
- Paint the entire cart with wood finish. Allow to completely dry before using the garden cart.