Previous Article

DIY Basic Plumbing Repair

Next Article

How to Write a Customer Testimonial for Plumbing Services

How to Do Plumbing Repairs

Plumbing repairs require either the use of a soldering gun, flux and solder or PVC pipe primer and glue. Older plumbing utilized copper pipes while newer plumbing is comprised of PVC. You must first determine which type of pipe you have to repair.

Items Needed:



  • Hack Saw

  • PVC Primer, Glue and Pipe with the correct fittings, if needed

  • Soldering iron, flux, solder, copper pipe and fittings, if needed


Before doing anything, do the following in this order:



  • Turn off the water supply, electricity and water heater.

  • Drain water currently in the plumbing system by opening all the faucets.

  • Close the shut-offs nearest the repair.



  1. Identify the location of the repair. This may require cutting through a vapor barrier or removing a bathtub to access it.

  2. Locate the problem. If plumbing has been leaking, for example, you'll probably see soaked insulation.

  3. Remove the wet insulation, allow the area to dry out and replace the insulation upon completion of the repair.

  4. Resolder a leaking copper pipe fitting if that is the problem. To do that, apply flux and resolder it.  

  5. Reprimer and reglue a leaking PVC fitting if that is the problem.

  6. Test the system after the repair by applying dish detergent to the repaired area, turning faucets off and introducing air into the system. Watch for bubbles at the repair site.

  7. Remove the damaged section of pipe and fittings with a hack saw if they are damaged.

  8. Replace the damaged sections with new pipe and fittings as required. Solder or use PVC primer and glue. You will need couplings to join ends where there were not fittings.