How to Dry Walnut Lumber
When lumber is exposed to water it can often damage the wood. The damage results in splitting, rotting, and mold. Once this begins to happen the wood is pretty much unusable, and can result in thousands of dollar in damages to replace it. There are several techniques that can prevent this from happening.
Air Drying
The simplest and cheapest way to dry wood is to let it air dry. To allow it to air dry simply place the wood in an area that is in direct sunlight. After 12 hours turn the wood over to allow it to dry evenly. Repeat these steps 2 to 3 times to allow the wood to fully dry.
Blow Drying
Another affordable way to dry wet lumber is to use a blow dryer. However, it can be rather time consuming. Lay the wood in direct sunlight and begin to blow dry a section at a time. Make sure to not dry one section too long as it can cause splitting. Also flip the wood after completing one side, and repeat the drying on the corners as well. If the wood is still damp place a fan near it while blow drying to allow it to dry quicker.
Wiping it Down
If the wood is outside you may allow the sun to aid in the drying as you are wiping it down. Use a rag to absorb as much moisture as possible. Once that rag is wet use another to soak up the extra moisture, and repeat as much as needed.