Previous Article

How to Extend the Life of Your Lingerie

Next Article

How to Fairly Value Your Used Car

How to Extract Gold From Electronics

The average consumer does not realize the amount of precious metals such as gold, silver and platinum that is found in electronic devices such as broken computer parts and other electronic scrap. The majority of this metal is contained within circuits and processing units contained in electronic devices. The process that is used to remove this gold from scrap electronics is called reverse electroplating.

Materials Needed



  • Safety glasses

  • Respiratory mask

  • Sodium meta nitro benzene sulphonate

  • Sodium cyanide

  • Glass beakers

  • Sodium hydroxide

  • 9 Volt battery

  • Wire

  • Stainless steel rod

  • Rubber apron

  • Small alligator clips


 



  1. Collect as much scrap electronics as are available to you. You will want to do a lot of items at a time if possible due to the mixing of chemicals that is involved.

  2. Remove all of the gold components from the scrap electronics. You will only need to complete the process on the items that contain the gold.

  3. Put all of your safety gear on in preparation of working with the chemical compounds that are needed for this process. Safety gear consists of protective eyewear, face shield, rubber gloves, rubber apron and a respiratory mask. This is very important to prevent accidental chemical burns and health risks that can occur from inhaling toxic fumes.

  4. Make an electrolyte solution to give your electronic products a chemical bath that will reveal the gold within. To make the electrolyte solution you will be pouring a mixture of 70-percent sodium cyanide, 15-percent sodium hydroxide and 15-percent sodium meta nitro benzene sulphonate. Be very careful when pouring these ingredients into a glass chemistry beaker; stir them thoroughly until well mixed.

  5. Hook two wires that have been stripped of insulation at the ends using small alligator clips to your battery that you are using as a power source. You will want to make sure that you hook one to the positive and one to the negative connectors.

  6. Take the wire that is now attached to the positive side of the battery and hook it to the electronic components that contain gold, using an alligator clip to secure. Once these are clipped securely drop the component into the electrolyte solution that you made. Continue this process until the battery has lost power. If you have more components to do, simply follow the same process and switch out the battery for a new one.

  7. Attach the second wire to a cylinder steel rod using an alligator clip. Once your wire has been secured to your steel rod, gently place it into the solution.

  8. Allow this solution time to work. It is suggested that you let it soak for approximately 5 minutes. During this time the electrolyte solution will be working to dissolve the gold from your scrap. Because the gold is positively charged from the electrolyte solution it will be pulled to the steel rod that offers a negative current. This causes the gold to form in a coating onto the steel where it can later be retrieved.

  9. Mix a refining solution. You will use this solution to refine the gold to its purest for which is 24-karat.  Fill a glass beaker half full with Aqua Regina. Use EXTREME caution when working with this chemical as it can cause extreme chemical burns. Wear very think heavy gloves in case of spills or splashes.

  10. Gently place the gold into the beaker filled with aqua Regina. Next, you will fill the beaker the rest of the way with sodium Meta Bisulphite. This chemical is added to eat the impure components that may be infused within the gold collected. The remaining pure 24-K gold will settle to the bottom of your beaker.

  11. Drain your refining solution, and keep for later uses. Allow gold to dry fully before handling because of the chemicals used in the process. Once the gold is dry, wash thoroughly with water.


 


TIP: Modern electronics do not contain as much gold as older models do. Companies have improved the process in making these electronics that require gold so that the minimum amount of gold that is needed is used.