Previous Article

How to Fix a Drain Snake

Next Article

how to Fix a Garage Door

How to Fix a Fuel Pump

The fuel pump is an essential part of any car. When this item goes bad, you can be left stranded on the side of the road. Even if the car continues to run, it can do major engine damage or result in poor overall engine performance. If you suspect the fuel pump, it can be fixed in just an hour or two

When a fuel pump goes bad, a car will no longer be able to run. Even if this part is still operational, when it starts to act up, you will notice poor engine performance. Engine damage may result. Fixing a fuel pump is not a difficult task though, even the electronic ones found in newer cars. In just one hour, the average backyard mechanic can replace a fuel pump.




  1. To replace a fuel pump, you will need a new fuel pump, a hammer, a wrench and a screwdriver. The first step in this process is to disconnect the battery. Remove the negative cable of the battery using the wrench. Next locate the bad fuel pump. Most are found within the fuel tank. Look under the vehicle's rear seat where an inspection hole may be found. In order to remove this seat, you will need to push the cushion down and to the back of the car. The track will come free and then the seat may be removed from the vehicle.


  2. An access cover will be in place over the fuel pump. Use the screwdriver to remove any screws holding the cover in place. Once this has been done, you will see the fuel pump sending unit locking mechanism. Disconnect the wiring harness of this unit by unplugging it.


  3. Next the fuel pump will need to be removed. A retaining ring will be holding it into place. To loosen this ring, place the screwdriver into the slots found on the ring. Tap the screwdriver with the hammer going in a counter-clockwise direction. Once the ring has been loosened, the unit may be pulled out of the tank. The wire harness will now need to be removed. Take care when completing this step. Remove the pump by pushing it down and out of the frame of the sending unit.


  4. Place the new fuel pump into the frame. Find the rubber seal that came with the new pump and place it on top of the new fuel pump. Insert the pump into the frame by pushing down until it pops into place. Now replace the screen with the new one included in the kit. Again, this should just snap into place. Reconnect the wiring harness and place it back into the fuel tank and reverse the steps to replace the access cover and seat. The work is now done and the car's performance will improve.