Previous Article

How to Build a Basement Storm Shelter

Next Article

How to Plan an Basement Renovation

How to Frame a Basement

Framing a basement can add valuable usable square footage to any home. The actual framing is something that a homeowner can do with a few tools and little to no carpentry knowledge. Take some time to plan your basement-framing project and that can help you achieve the look and layout that will make the most of the basement space.         

Items Needed:



  • Hammer

  • Tape measure

  • Staple gun

  • Nails or screws

  • 2"X4" lumber

  • Insulation board

  • Roll insulation

  • Powder-acutated nailer

  • Concrete adhesive

  • Circular saw

  • Drywall saw



  • Decide how much of the basement will be framed. Framing the perimeter walls will create one large room, but it will be warm and comfortable. Framing internal walls as well will create individual rooms.

  • Always begin with perimeter wall framing. Even if creating interior walls frame out the perimeter first to give the interior walls structure.

  • Ensure basement walls have adequate drainage and remain dry. If the outside of the walls do not drain properly, the walls will leak into the basement in bad weather.

  • Add insulation to the basement walls prior to framing.  Fiberglass insulation board is the recommended type of insulation for a basement wall application.

  • Construct the framing using 2”X4” construction. Using 2”X4” studs in framing the walls allows for additional insulation in the bays created by the framing.

  • Install a top and bottom plate on the perimeter walls. The top plate nails or screws directly to the wood floor joists in the basement ceiling. The bottom plate attached to the concrete floor using concrete adhesive and a powder-actuated nailer.

  • Measure each wall stud before cutting to length. Basement ceilings are not normally level so stud length is not going to be the same for each area.

  • Tap the studs into place between the top and bottom plates at a distance of 16” apart and secure with nails. This ensures a stable framing structure and room for roll insulation installation.

  • Install roll insulation and staple into place in bays. Stapling ensures that the insulation will not slump over time, creating gaps.

  • Install drywall over the framing to create a finished look. Repeat the same framing and installation process on the ceiling to install drywall in that area.