Previous Article

How to Customize Aggressive Skates

Next Article

How to Paint Aggressive Skates

How to Front Side Grind on Aggressive Skates

The Front side grind is a great trick for beginners to the world of aggressive inline skating tricks. Speed and balance are key factors in the success of a front side grind. When completed successfully, the front side grind is fluid trick that can be used to transition from one trick to another in a routine.

Things you will need:



  • Aggressive inline skates

  • Protective safety gear

  • A rail or proper grinding surface


When performing a new trick on aggressive inline skates, wearing proper safety gear can greatly reduce the chance of personal injury. It is also required for many facilities and tournaments and by law in some areas. Always become comfortable with the mechanics of the trick and attempt a few approach and practice runs to increase both your safety and chances of success.


A front side grind is any grind performed on the h-blocks of your skates with your feet pointing towards the edge of the object you are grinding. A low, level rail is recommended for starters. However, once you get comfortable any adequately prepared lip or ledge can make an ideal front side grind surface.



  1. Approach the start of the rail at a cautious, but solid speed. This grind tends to carry momentum well and until you get the hang of balance and positioning, attempting to front side grind too quickly can result in disorientation and injury.

  2. Focus on your intended starting point on the rail.

  3. Jump when near the rail and rotate 90 degrees, placing your dominant foot horizontal to the bar. If performed properly, the rail should be positioned on your h-blocks, between the center wheels of your skates.

  4. Keep your feet at approximately the same width as your shoulders and flex your knees. This will help to maintain your center of balance on the rail. If you are grinding a lip or curved rail, lean into the curve to maintain proper balance. This is common mistake for many beginners, as placing your feet too close and not absorbing the movement with your knees will result in instability and make the maneuver difficult.

  5. Spot your landing spot after the rail and prepare to dismount by bending the knees slightly.

  6. Jump from the rail and rotate 90 degrees in the opposite direction. Your wheels should be aligned in the direction you want to continue skating in upon landing.