How to Grout Groutable Vinyl Tiles
Vinyl tiles come in many different styles and designs, including versions with the option of grout between the seams. Grouting the joints between the tiles helps secure the edges to the base, and also prevents water from seeping between the tiles. The grouting procedure is different than for ceramic tiles.
Supplies
- Acrylic-based vinyl tile grout
- Float
- Sponge
- Bucket
- Put a small dollop of the acrylic-based grout onto the float. Insert the grout into the joints of the tiles. The float should be held in an almost vertical position as it is pulled across the tile joints. The grout should not be spread across the tile's surface, as it's done with ceramic tile installation.
- Work carefully applying grout to a small number of tiles at a time.
- Remove excess grout from the joint by holding the float at a 45-degree angle and pulling it across the joint. Use care not to dig out any grout between the joints, causing an unleven surface.
- Allow the grout to harden slightly.
- Fill a bucket with warm water and submerse your sponge.
- Wring the sponge out until almost dry.
- Use it to wipe down the entire tile floor, removing any left-behind grout on the tiles.
- Rinse the sponge frequently to make sure clear water is being used to clean the tiles.
- Check to make sure the tiles have a shiny, rather than hazy, appearance. Use a new piece of your flooring to make the comparision.
- Allow the floor to dry for 24 hours before walking on it.