Previous Article

How to Clean a ClosetMaid Organizer

Next Article

How to Install ClosetMaid Wire Shelving

How to Install ClosetMaid

An affordable and practical option for your closet space is the installation of a ClosetMaid. This option will allow you to make the most of your pre-exiting space. The process of installing a ClosetMaid is simple and requires very little tools and experience.

What You'll Need:



  • ClosetMaid shelf track system

  • ClosetMaid caps

  • Drill

  • Level

  • Pencil

  • Hacksaw

  • Tape measure

  • Wood screws (1 inch)

  • Toggle bolts



  1. Carefully measure your closet space. Ensure that your walls are square and your floors are level. Consider using a pencil to mark for any adjustments you'll need to make before you begin installing the system. You'll also need to mark the exact spacing and position of the long track you'll install as part of the ClosetMaid. Finally, mark the supporting shelf location on the walls.

  2. Hang the long or horizontal track of the system on a level line in an area as close to the ceiling of the space as possible. Screw the track directly into the wood header of the wall near the ceiling. Use the 1 inch screws to complete this step. If necessary install the lower track of the system using the toggle bolts for drywall or wood screws for the installation of the stud.

  3. Hang the shelf tracks of the system installing the studs whenever possible. If you plan to install your ClosetMaid system to drywall, thread each of the bolts directly through the standard and reattach the toggle before you attempt to reattach the track. Repeat this process for the vertical shelf supports as well.

  4. Attach each of the shelf brackets. Slide each one of them into the slots as marked on the standards.

  5. Carefully measure and mark each shelf, hanging track and rod. As with most other projects, your accurate measurements are essential to the overall functionality of the unit. Cut them with a hacksaw to match the desired size. Cap each of the meal rods and shelves with the caps that came along with your system.

  6. Hang each of the shelves and rods on the supports.