How to Install Granite Countertops
Granite countertops are a great option for any kitchen. Granite is heat resistant and a hard material. The countertop will have to be sealed so stains are not absorbed. Go to your local home improvement store with your measurements to have the granite countertop cut. The following are steps to take when installing countertops.
Items Needed:
- Putty knife
- Tape measure
- Screwdriver
- Adhesive
- Epoxy glue
- Flat bar
- Measure the countertop area. Then take the measurements to your local home improvement store. They will cut the new granite countertop to fit in your kitchen. Keep in mind to measure the opening for the sink. Then your sink will fit back into place when the new granite countertop is installed.
- Remove the sink and fixtures. Use a putty knife to break the sink loose from the glue. Also remove the backsplash behind the sink.
- Move any appliances that are in the way of the countertop. Make sure the water and power have been shut off.
- Put the epoxy on top of the cabinets where the countertop will be placed. This will secure the countertop to the cabinets underneath. Get the help of friends to bring the countertop inside.
- Use the epoxy to glue the sink onto the underneath side of the countertop. This will be done before the granite countertop is laid in place. Hold the sink in place by using clamps to hold the sink in place. Let the epoxy dry. When the epoxy on the sink is dry, install the granite countertop.
- Use adhesive glue to glue the backsplash to the wallboard.