How to Install Metal Roof Flashing Against Brick
Metal roof flashing is a type of galvanized sheet metal. The metal is bent to a 90 degree angle around 8 to 12 inches on the sides of the angle. Metal roof flashing comes in 10 foot or six inch lengths. It is great for sealing the gap between intersecting roofs and walls.
Things you will need to install metal roof flashing against brick:
- Circular saw
- Concrete cutting blade
- Clear silicone caulk and caulking gun
- Metal roof flashing
- Chalk line
- Metal cutting scissors
- Pick the right flashing size. Most of the time, an eight inch flashing will be fine, any size will work.
- Put the base flashing beneath the shingles or above the metal roofing material. If the roof is flat against the brick wall, put in the roof side of the flashing beneath the last layer. Or you can put it above the roof material, if it happens to be metal.
- Use the step method for angled roofs. This will entail using flashing lengths of six inches. Be sure to start at the bottom of the angle and work your way up.
- Caulk overlapping seams where the flashing meets. Do the same for any exposed nail heads, as well.
- Create a straight line that is two inches over the back of the base flashing. Take a circular saw and masonry blade to cut an opening of 1 1/2 inches into the brick. The overlapping flashing or counter flashing should fit right into the opening. Then caulk the slot after the flashing is put in.