How to Install Patio Screen Doors
A screen door makes a great addition to a patio. It allows for cool air to filter into the home during the spring and fall, and provides a good view of your patio. This is particularly important to parents of young children, who may be playing on the patio or backyard.
What you will need:
Measuring tape, power drill, Phillips screwdriver, hacksaw, 2 1/2" plastic pipe, 1 1/2 inch screws
Directions:
- Cut the screen and storage cassette to the dimensions you need to accomodate your doorway using a hacksaw. To make sure it will fit correctly, cut the screen 1/8 inch smaller than the doorway's width.
- Fasten the plastic caps into the cassette's ends, affixing the handle for the screen.
- Use your screwdriver to screw the mounting clips into their position on the upper part of the door. Make sure that the clips are mounted so the lip is facing the door.
- Click the storage cassette into place with the mounting clips. Draw a horizontal line under the cassette at the side jambs.
- Pull out the cassette. Measure the door, starting at the sill and moving up where you marked horizontal lines. Then, take 1/8 inch away from the number. Take the hacksaw and cut two tracks for the side to accommodate the measurements just made.
- Return the cassette to its position over the doorway. Place the tracks into position on both sides of the cassette. Make four small holes through the sidetracks with your power drill and into the door sill. Screw wood screws in the holes you just made using the power drill and screwdriver bit attachments. Put the plastic pipe into place in the track, pushing aside the weather stripping to give room to add screws.
- Check the screen by moving it vertically up and down. The tension can be adjusted by removing the caps from the cassette. This can either loosen it or make it tighter.