How to Install RAM on Notebook Computers
Installing RAM in your notebook computer is a simple and affordable way to increase your notebook’s performance. The process is simple. It only takes a few minutes and can provide noticeable improvements to your notebook’s responsiveness and multi-tasking capabilities.
Things you will need:
- A precision Philips or flat-head screwdriver
- Small tray to collect small screws
If you do not need to remove existing memory, skip steps 8 through 10.
- Power off your notebook computer.
- Remove the battery by sliding the release tabs and pulling gently on the battery.
- Press the power button on the computer to discharge any remaining power.
- Place the notebook on a flat surface, with the bottom facing up.
- Locate the memory bay door. This is typically a small door secured by one or two screws. There is often a label on the door depicting a small memory stick or labeled “memory” in small print.
- Remove any screws securing the door and place them in a tray.
- Gently lift away the door, exposing the memory sticks.
- Locate the clips on the side of the memory sticks. These clips holds the chip in place.
- Gently pull the tab to the side. The memory stick should raise slightly.
- Grasp the memory stick on the corners and pull gently. The memory stick should lift away with little or no resistance.
- Pick up the memory stick you want to install by the edges.
- Insert the memory stick into an open slot. The chip should be held at a 45-degree angle and gentle pressure used to avoid damaging the notebook or memory chip.
- Press the memory chip towards the bottom of the laptop, using gentle pressure, until the clips snap in place.
- Replace the memory bay door.
- Replace any screws securing the memory bay door.
- Replace the notebook battery.
- Power on the laptop to confirm proper installation.