Previous Article

Options for Patio Door Blinds

Next Article

How to Open Patio Doors

How to Install Sliding Glass Patio Doors

Sliding glass patio doors are a favorite choice for new additions and conservatories because they make for a stunning appearance on outdoor enclosures. Adaptability means they can be used as garden room doors, greenhouse doors, sunroom, patio doors, and on enclosed swimming pools. Sliding doors merge your house with the outdoors, creating a seamless entry. They are also used as external doors that bring in natural light.


 



Tools:

  • Level

  • Hammer

  • Chisel

  • Measuring tape

  • Plumb bob

  • Caulking gun

  • Wooden shims

  • Finish nails

  • Screws

  • Screwdriver





  1. Use a level to gauge the floor by inserting shims until bubble is at centre of level.

  2. Use a plumb bob to check if wall and trimmer studs are plumb, then use wood shims to plumb trimmers. Use tape to mark hinge locations on the hinge side trimmer. Measure starting at bottom of jamb up to the middle of each hinge.

  3. Attach plumb bob on top of the hinge side trimmer, use tape to measure distance between the string and every hinge point.

  4. Place shims to overlap at the smallest distance and nail to secure. Alter thickness of shims until their distance is equal to the first hinge. Secure shims to trimmer with finish nail.

  5. Install the door, holding it in slanting position with bottom first. Use 8d or 16d finish nails to hold the door in place temporarily (nails shouldn't be all the way inside yet).

  6. Swing the door open and closed to see if it freely swings. Close the door and check if the contact between door face and weather-stripping on frame adjacent to hinge jamb is even. If not adjust the jamb until even.

  7. Observe door edges from inside while door is closed. Ensure a uniform gap of 1/8 inch between door edges and jamb.

  8. Place a shim at the lock strike location. Tack the jambs permanently with nails or screws. Insert nails through shims to avoid moving doorframe out of position.

  9. Install insulation on frame edges, either with foam or fiberglass. Seal trim joints with caulk.