Previous Article

Solar Water Heater Techniques

Next Article

About Illegal Immigration Laws

How to Install Tankless Electric Water Heaters

A tankless water heater heats water on demand, instead of storing it in a tank. The primary advantage of this type of water heater is to save the homeowner money. The installation procedure for a tankless water heater requires the ability to solder copper pipes with a propane torch.

Things You'll Need:



  • Mounting screws

  • Screwdriver

  • Copper pipe and fittings

  • Sandpaper

  • Flux jelly

  • Propane torch



  1. Select an installation site for the tankless water heater that is close to the water outlet, usually under a sink. Ensure the water heater's electrical cord can reach an electrical outlet.

  2. Drill pilot holes into a stud and mount the tankless water heater to the stud with the mounting screws that came with the heater.

  3. Shut off the water supply to the house, usually by turning a knob on the water pipe before it enters the house.

  4. Cut a copper pipe of the right length with a pipe cutter, and cut the the existing cold water line. This allows you to reroute cold water into the tankless water heater. Clean the ends of the copper pipe with sandpaper until the pipe is shiny. Apply a thin layer of flux jelly to the ends of the pipes and the connectors.

  5. Solder one end of the copper pipe to the cold water line with a propane torch. Solder the other end of the pipe to the inlet line on the tankless water heater.

  6. Cut a length of copper pipe the proper length to connect the water outlet on the tankless water heater to the pipe for the hot water. Clean the pipe with sandpaper and solder it into place.

  7. Turn the water supply on and correct any leaks in the pipes.