Previous Article

Troubleshooting a Hot Water Boiler

Next Article

How to Recycle a Hot Water Heater

How to Install a Hot Water Heater Timer

A hot water heater timer reduces energy use and saves electricity. You set the timer to turn off the heater at a designated time throughout the day. This keeps your heater from running when you are not using water, such as during the night while you are asleep or during the day while you are at work. You can easily learn how to install a hot water heater timer and begin saving electricity.

Things You’ll Need



  • Hot Water Heater Timer

  • Pencil

  • Drill

  • Screwdriver

  • 10 Gauge Electrical Wire

  • Wire Strippers


Instructions



  1. Flip the breaker that supplies electricity to the hot water heater to the "off" position at the breaker box. 

  2. Remove the timer from the case and punch out the knockout holes on the case. 

  3. Locate a stud on the wall that is close to the hot water heater. 

  4. Place the case at the chosen location on the wall and mark the screw holes with a pencil. 

  5. Use the drill to make the holes at the marks on the wall. 

  6. Mount the case on the wall with the screwdriver using the screws that came with the timer. 

  7. Use the screwdriver to unscrew the plate that is located on the top of the hot water heater. 

  8. Remove the electric cord that was under the plate and thread it up through a knockout hole on the case. 

  9. Strip about one-half inch of insulation from one end of the new electrical wire with the wire strippers and run the new wire from the case to the water heater. 

  10. Connect the wires by matching them to the color coded wires on top of the hot water heater. 

  11. Use the wire strippers to strip about one-half inch of insulation from the other end of the new electrical wire. 

  12. Place the timer back into the case by firmly pressing it into the case. 

  13. Attach the bare wire ends of the stripped wires to the lugs on the timers and bend them so that they fit securely. 

  14. Tighten the screws that hold the new wires in place by using the screwdriver. 

  15. Set the timer on the hot water heater by referring to the manufacturer’s instructions. Turn the breaker at the breaker box back to the "on" position.