How to Install a Radio in a Kia Rio
Though your base model Kia Rio comes without a stereo, you can still install one later by following a few simple steps. If you purchased the optional radio, you can still uninstall the factory unit and install your favorite deck.
Supplies:
- Wire strippers
- Phillips screwdriver
- Flathead screwdriver
- Butt connectors
- Wire harness kit
- Replacement stereo
- If installing a new deck into a base model Kia Rio, locate the plate that covers the radio cut out. Slightly pry the plate forward and peek to locate and unlatch the clips using your flathead screwdriver. If no clips are found, simply pry the plate forward until it releases. If you want to replace your factory unit, slide it forward and out. Then remove the support brace from inside the radio cut out.
- Use your wire strippers and butt connectors to install your wire harness kit. Your wire harness kit will plug directly into your new radio, which allows for a much cleaner install.
- Plug your new radio’s wire harness into your newly installed harness. Locate your antennae wire and plug it into the back of your radio. Your antennae wire allows your radio to pick up local radio stations.
- Fit your radio into the cut out in the dash. Push the entire unit into the dash until the front lip of the radio lies flush with the dash.
- Turn on your radio and tune to your favorite station. Set your bass and treble to levels that are pleasing to your ears. Adjust volume and enjoy.