How to Lay Bathroom Tile
There are many choices to choose from when it comes to selecting tile for the bathroom. No matter which style you choose, the tile must be installed properly to make the bathroom area look great. Installing tile is not a difficult process but can take some time to complete.
How to Lay Bathroom Tile
Materials Needed
- Wrench
- Pry bar
- Tiles
- Soap
- Water
- Broom
- Mop
- Chalk line
- Mortar
- Trowel
- Spacers
- Grout float
- Grout
- Sealer
- Flush the toilet to remove the water. Make sure the water is turned off with the valves in the rear of the toilet. Remove the screws in the toilet with a wrench. Remove the toilet and take it out of the bathroom.
- Take a pry bar and use it to remove the baseboards. Place them to the side. Use the pry bar to remove the tile from the floor.
- Sweep the bathroom after all of the tiles are removed .Use soap and water to clean the area. Make sure all of the soap is rinsed away. Allow the area to dry.
- Find the center of the room. Snap a chalk line in that area. This is where you will begin installing the tile. It is a good idea to start in the middle of the bathroom and work outwards so you do not have to step on your finished work.
- Combine the mortar with water according to the directions on the package. Scoop up some of the mortar mixture with a trowel and apply it to the center section of the floor. Work on one small section at a time to install the tile.
- Press the tile into the mortar. Continue applying the mortar to the floor and pressing the tiles in it until the entire bathroom is complete. Make sure spacers are used between each tile, which will keep the tiles even.
- Allow the floor to dry for 24 hours. Remove the spaces. Use a grout float to apply grout between the tiles. Wipe the area with a damp sponge. Allow the floor to dry for two days. Cover the floor with a sealer and allow the area to dry for one complete day.