Previous Article

Tools for Making Equine Bits

Next Article

How to Find a Horse Fly Mask With a Funny Face

How to Make Equine Clothing

There are several occasions in which a horse may need to wear clothing. One method to make this such clothing is to use articles of tack with which the horse is already familiar and convert them in to the base of the new Western shirt and hat for the horse.

What You'll Need:



  • Saddle pad

  • Horse boots

  • Sweat sheets

  • Underbelly clips for sweat sheets

  • Measuring tape

  • Velcro strips

  • Sewing machine

  • Thread

  • Scissors

  • Fabric glue

  • Old Stetson hat

  • 2-inch by 8-inch gross grain ribbon

  • Yardage

  • 1-yard interfacing

  • 1-yard of faux leather for boots



  1. To create the hat you'll first need to use measuring tape to measure the distance between the horse's ears plus 1- inch for extra room. Use an old Stetson and put holes through it which you will pull the horse's ears.

  2. Make sure that the hat will not slide around; you can use fabric glue to affix two 4-inch strips of Velcro onto the inside back of the hat on each side directly on top of the spot where the horse's halter fits behind the ears. Cut two 4-inch pieces of gross grain ribbon and stitch a 2-by-2-inch square of Velcro to each end of the ribbons. One end of the ribbon will connect to the hat while the other end will feed through the halter and back up, where it connects to the Velcro strip at the back of the hat. Repeat this step with the other ribbon.

  3. To convert a sweat sheet into a Western shirt for your horse you'll need to use measuring tape to measure the sweat sheet. Visit a fabric store and purchase enough fabric to cover the sheet plus an additional yard. Select a fabric that resembles a cowboy shirt collar.

  4. Use the original sweat sheet as a pattern for the body of the shirt. Stitch a 1-inch Velcro fastener onto the sweat sheet at 6-inch intervals. Hem the lower edge of the shirt material and stitch the Velcro fasteners onto the material. 

  5. Finish the Western style collar; measure the sweat sheet beginning at the shoulder and moving across to the opposite shoulder, this will figure the width of the inside of the shirt collar. On a sheet of newspaper create a pattern for a Western collar that measures 5-inches wide by the measured width of the collar and draw in standard collar points.

  6. Pin together the pattern and the yard of interfacing onto the double fold of the remaining yardage then cut it out. Stitch completely around the fabric but make sure to leave a 6-inch un-stitched area at the center of the inside neck. Trim off the edges and flip the collar right side out. Hand stitch the un-stitched area shut. Connect Velcro to the body of the shirt at the neck line as well as on the inside of the collar. Stick each of them together to complete the shirt.

  7. Open up the commercial boot and trace around it to draw a pattern for your horse's leather boots. Add an extra 2 inches in width for closing. Then either stitch or glue Velcro onto the edges of the boot as well as to the edges of the faux leather and overlap the closure by 2-inches so that the underboot does not show.