Previous Article

How to Make Blue Bird Houses

Next Article

How to Pick Garden Bird Houses

How to Make Gourd Birdhouses

Growing your own gourds is a neat experience and the final reward comes when you design and create your own birdhouses. Learning how to make gourd birdhouses is fun and easy to do. No two gourds look exactly alike, so each birdhouse is a one of a kind. You will need a couple of tools, plenty of drying time and a bit of creative design.

Required Items



  • Sandpaper

  • Bleach

  • Drill and bits

  • Wire or string

  • Kettle gourd

  • Polyurethane




  1. Grow your own gourds from seed. After the vines die back select a good-sized gourd with enough room to hold the bird species you are building it for. It is a good idea to choose a couple of extra gourds for backup in case you make a mistake when constructing the birdhouse.




  2. Let the gourds dry. The size and thickness of each gourd will determine how long it takes for it to thoroughly dry out. You can assume it will take a minimum of two weeks or as long as several months. When you can hear the sounds of seeds rattling around inside as you shake the gourd, you know it is finally dry.




  3. Preserve the gourd to protect it from fungal molds and rot. Use a wire brush dipped in soapy water and scrub the gourd. Put the gourd in a solution of water with 10% bleach for about 15 minutes. Remove from the solution and let the gourd air dry completely.




  4. Cut the entrance hole, drainage holes and hanging hole in the gourd. Wear a protective facemask to protect against the gourd dust while drilling. Research what size hole you need for the entrance based on the species of bird that will be nesting. Cut an opening for the entrance just above the center using a drill. Drill three or four small drainage holes in the bottom and one hole at the top to put string through for hanging the birdhouse.




  5. Remove gourd debris and seeds from the gourd through the entrance hole using a spoon. Sand any rough spots on the holes made from drilling.



  6. Seal the gourd. Lightly sand the outside with sandpaper and clean off the dust. Apply a coat or two of polyurethane to seal and keep a natural look. Feed wire or string through the hanging hole and place it in a tree the suitable distance from the ground for your bird species.