How to Make a Homemade Water Hydroponic System
Growing plants inside your home can be messy and cause bugs to infiltrate your home. This is the reason most people do not grow plants inside; however, there is an easier, much cleaner way to grow plants indoors. All you need to do is build a water hydroponic system. This system does not use soil and it will not attract bugs.
Here is how to make a homemade water hydroponic system.
This system will be approximately 3.5 foot by 8 foot and will allow plants to grow nearly 6 foot in height. Make sure that you have a space big enough in your home for this system. Depending on the space, you may want to make a smaller system.
You will need four 10-foot pieces of PVC pipe, eight 4-inch PVC elbows, one 30-gallon storage tote with a lid, hydroponic pump that can filter 200 – 400 gallons an hour, four feet of hydroponic pump hose, forty 16-ounce plastic cups and clay pellets. These items can be purchased at Home Depot, Lowe’s or your local hardware supply store.
Cut and connect the PVC pipe so you have a snake type unit. You should have four straight areas and three curves. Be sure to use water-proof glue when connecting the PVC pipes.
Mark dots along the straight lines of the structure. The dots are where you will cut out a hole for your plants. You should leave at least ten inches between dots, depending on the type of plant you will be growing.
After the holes have been marked, you should drill the holes using a 2 ¾ inch hole bit.
Once the holes are drilled, you will need to drill holes in the plastic 16-ounce cups. These cups will be your netting pots for your new hydroponic system.
Connect the cups to your pipes. Make sure the holes line up directly.
In your 30-gallon storage tote, set up the hydroponic pump with hoses. You should connect the ends of your PVC pipe so they can reach the water in the tote.
Fill the tote with water and growing solution.
Turn the pump on. Water should be running through your PVC pipes.
Put the clay pellets in the bottom of the cups with the seeds or starter plants.
The roots of your plant will reach into the PVC pipe, where the water is flowing. You should clean the water and add solution as needed.