Previous Article

How to Charge a NiMH Battery

Next Article

How to Recycle Rechargeable Batteries

How to Make an NiMH Battery

Nickel metal hydride or NiMH batteries are rechargeable batteries that are widely used to power electrical devices. The batteries produce 1.2-volt output, which is often not enough to use as a single cell. You require a pack, which can prove to be expensive. Building your own battery pack of cells is a cheaper option that is fairly easy to construct.

Materials



  • NiMH batteries

  • Wire and wire strippers

  • Knife

  • Insulation tape

  • Solder and soldering iron


Procedure



  • Read the instructions on the equipment you want to power and calculate the power you require. This will give you an idea of the number of batteries you need to use.

  • Lay the batteries you need and line them up on a flat surface. The batteries should alternate between positive and negative. If the first one is positive, the second negative, third positive, fourth negative, and so on.

  • Mark each of the batteries by numbering each one, and then use the insulating tape to attach them together.

  • Cut the gauge wire into one inch strips, one strip for each battery you are using and add one extra strip. Two of the strips should be longer than the rest.

  • Strip off a bit of plastic from the wires to expose the metal core.

  • Attach one of the longer wires to the positive terminal of battery number one by soldering it on. Solder on a strip of the small wire to the negative terminal of the same battery.

  • Connect the short wire on battery one to the positive terminal of battery two. And do the same with all the batteries. Connecting the positive to the negative terminals in all the batteries. Use the solder and soldering iron and remember to let each one cool before you move to the next.

  • Solder the other long wire to the negative terminal of the last battery in your series, wait for the batteries to cool and then wrap the whole pack including the wires, using the insulating tape.

  • Attach the two long wires at the end of the pack to the electrical device and turn it on. The NiMH battery pack is in use.