Previous Article

How to Install Vinyl Rain Gutters

Next Article

How to Remove Rust From Rain Gutters

How to Mount Rain Gutters on a Roof

Every house must have a working gutter system to protect the roof and truss system from rainwater damage. Gutters prevent rainwater from spilling down the sides of the house. They channel the water into a drainage downspout to be directed away from the structure. Installing gutters can be accomplished by anyone who has basic carpentry skills and a few tools.

Supplies



  • Ladder

  • Gutter

  • Fascia brackets

  • Pencil

  • Chalk line

  • Level

  • Electric screwdriver

  • Silicone sealant

  • Saw

  • Screws






  1. Use a ladder to reach the roof of your house. Measure the eaves where your gutter will hang. Write down your measurements.

  2. Examine the area where the gutters will be installed. Check the fascia board to make sure it is sturdy and not weather damaged. Gutters are typically mounted on this piece of wood, and it needs to be secure to provide a strong base for the gutter system.

  3. Use chalk to place a line on the fascia board where the gutter brackets will be mounted. Remember to allow a 1/2 inch of fall for each 10 feet. This will allow the channels to drain properly.

  4. Lay out the gutter material and join the pieces together. Gutter usually comes in 10 feet sections. 

  5. Install the fascia brackets with your screw gun along the chalk line you marked. The brackets should be 16-inches on center. This will provide a sturdy base for holding up your gutter and water that flows through it.

  6. Once your brackets are installed place the joined gutter pieces into them. 

  7. Place the end cap on the gutter channel opposite the downspout. 

  8. Install necessary elbow connectors on the end near the downspout.

  9. Attach the downspout to the connecter.

  10. Protect all joints with a silicone sealant. This will keep your gutter from leaking.

  11. Test your installation with a water hose. Hook up the hose and introduce water into the gutter on the end away from the downspout. Make sure the water flows toward the downspout and drains. If it does not, the fascia brackets must be adjusted to add more fall to the gutter channels to drain properly