Previous Article

The Average Transmission Replacement Cost

Next Article

How to Drain Some Transmissions Fluids

How to Perform an Automatic Transmission Service

Your automatic transmission supplies power to your car's wheels. You may find yourself stranded if your transmission is not maintained properly. It is best to change your automatic transmission fluid and filter at least every 30,000 miles to acheive optimum life and performance from your automatic transmission.

Items Needed:



  • Ratchet set

  • Car ramps

  • Draining pan

  • Drain plug tool

  • Transmission fluid

  • New transmission filter

  • Shop rags 

  • Gasket scraper 

  • Socket wrenches

  • Longneck funnel



  1. Pull your car up onto your car ramps and engage your parking break.

  2. Get underneath your vehicle and find your transmission’s pan. Your transmission pan is usually made of sheet metal and it sets on the very bottom of your transmission.

  3. Put a big draining pan underneath your transmission’s pan.

  4. Find your transmission drain plug. It should be mounted somewhere inside your transmission’s pan.

  5. Get a drain plug tool for transmissions from an auto part supplier and unscrew your transmission drain plug by turning it counterclockwise.

  6. Take your drain plug off and place it on your work bench.

  7. Wait a few minutes for all of your transmission fluid to pour out into your draining pan.

  8. Put your transmission’s drain plug back inside your transmission’s pan and make sure it is tightened thoroughly. (Skip Steps 6, 7 and 8 if your transmission doesn’t come with a drain plug.)

  9. Unscrew and remove all but two of the retaining bolts on your transmission pan using your socket or ratchet.

  10. Hold onto your transmission pan while you loosen the two remaining bolts and take them out.

  11. Pour all of the contents of your transmission pan inside your drain pan if you did not do Steps 6, 7 and 8.

  12. Wipe down the inside of your transmission’s pan using your shop rag.

  13. Take off your gasket using your gasket scraper.

  14. Install your new gasket inside your pan. Make sure all the holes of the gasket line up with the mounting flanges holes.

  15. Tightly grab your transmission filter. You should be able to see it pretty easy after you take your pan off. Pull your filter out of your transmission by twisting it.

  16. Dump all of the old fluid out of your old filter into your transmission drain pan.

  17. Twist your new filter in place of the old one. Twist it until it figs snug.

  18. Tighten all of your retaining bolts using a criss-cross pattern with your ratchet and socket. Make sure you don’t tighten the bolts too much and damage your gasket.

  19. Pop your hood and take out your transmission dipstick near the back of your engine.

  20. Put a longneck funnel down inside the transmission’s opening.

  21. Pour the proper amount and type of transmission fluid into the funnel per your vehicle's owner's manual.

  22. Push your dipstick back into your transmission and check the level of transmission fluid.

  23. Put your key in the ignition and start your car.

  24. Let your car warm up to normal operating temperature and check your transmission’s fluid level once more.

  25. Make sure your fluid reaches the “full,” mark on your dipstick. Add just a little fluid at a time, and make sure not to overfill your transmission.

  26. Shut your hood and put your vehicle in reverse to drive off your ramps.