How to Program a Remote for an STS Cadillac
Cadillac provides vehicle owners with a set of instructions to program their remotes within the manufacture vehicle warranty. Whether you do or don't have a programmed remote, the process for programming a remote can be done in very little time with a fairly low level of skill.
If You Have One Programmed Remote
- Turn your Cadillac STS off and ensure you have all the remotes with you, including the remote that is already programmed.
- Place the key to your vehicle into the driver's side door lock and turn it into the "unlocked" position five times within a period of five seconds.
- On your Driver Information Center, or DIC, located inside your vehicle, you should see "FOB" mode entry displayed. It should read, "Ready for FOB 2,3 or 4". Keep in mind, you are only able to program up to four remotes.
- Open the center console of your vehicle and locate the transmitter pocket. Ensure that the transmitter button is facing the front of the vehicle. Wait for a beeping sound, this will let you know that the remote is programming.
- Remove the remote from the transmitter pocket and press the "Unlock" key twice to compete the programming process.
If You Don't Have a Programmed Remote
- Turn your vehicle off and insert the remote into the transmitter pocket that is located within the center console of your Cadillac STS. Ensure that the buttons are facing toward the front.
- Position your key inside the door lock on the driver's side and turn the key in the "unlock" position five times within a five second period. Your DIC within your vehicle should read "OFF/ACC TO LEARN".
- Push the "ACC" button that is located on your ignition switch. Your DIC will then advise you to wait ten minutes. At the end of this period it will read "OFF/ACC TO LEARN". Once that has been displayed, press the "ACC" button on the ignition switch four times.
- Wait for a beep, once you've heard it your DIC will read "FOB Ready for #2".
- Remove the remote from the transmitter pocket and press the "Unlock" button twice in order to complete this programming process. Repeat these steps to program up to four remotes.