Previous Article

How to Rate Term Life Insurance Companies

Next Article

How to Read a Health Insurance Plan

How to Re-Upholster Cushions

There will eventually come a time when you will want to re-upholster your chairs. Not only will this make them look new again but it will also give your room a whole new look. With this in mind, here are the instructions that you will need to follow in order to re-upholster your chairs.

You can give a room a great new look simply by changing the type of upholstery that is on the cushions on your furniture. This is easy and quick to do as long as you follow these steps:


1. Turn your chair over and use a screwdriver to take out the screws that hold the cushion into place. These are usually located in the chair’s four corners.

2. Take the chair cushion off of the chair.

3. Use a pair of needle nose pliers to remove the staples from the bottom of the chair cushion. These are what hold the fabric onto the chair. Once they are removed, you can peel the fabric away from the cushion.

4. Remove any foam from the chair so that you only have the chair’s bottom board.

5. Trace around the board onto a piece of foam then cut it out.

6. Spray some adhesive spray onto the foam and put it onto the chair’s board. Press down hard so that the foam will adhere to your board. You will not need to hold it there as once it is pressed down the adhesive will stick.

7. Put the board, with the foam facing down, onto the new fabric. Pull the fabric up around the board so that it will cover two inches of the board on each edge. Now it is time to cut the fabric out.

8. Place the board with the foam facing down onto the fabric. Pull the fabric up and staple it into place. The first staple should be in the middle, as it will hold the fabric into place. Remaining staples should be one inch from the board’s edge. Continue stapling until you have one side secure but don’t staple the corners yet.

9. Staple the opposite side of the board into place. Then work on the other two sides as well.

10. Pull the fabric in the corners onto the board. Make pleats in the fabric and staple it into place. This must be done for all four of the corners.

11. Once all of the fabric is stapled into place, use a pair of scissors to trim off any extra fabric.

12. Put the seat back onto your chair’s frame then use your screwdriver to put all of the screws back on so that the cushion will be held in place.