How to Rebuild an Electric Motor
If you are a remote control toy hobbyist, you know the importance of maintaining the electric motors which drive the remote controlled vehicles you enjoy playing with. If you don’t pay attention to them, they will wear out very quickly. You can learn how to rebuild an electric motor.
Supplies:
- Phillips screwdriver
- Motor commutator lathe
- Silver permanent Sharpie marker
- Electric motor you want to rebuild
- New brushes
- Solder
- Soldering iron
- X-Acto knife
- Start by taking apart the motor. Do this by unscrewing the electric motor springs with a Phillips screwdriver. Pull out the old brushes by the wire. Do this before removing the end bell.
- Pop off or unscrew the end bell. To take off the end bell, twist and pull it apart. Keep in mind where the screws are and how close they are to the magnets. The timing can be adjusted, and is fixed on the motor.
- Fit the motor on the lathe. Follow the lathe’s instruction booklet when fitting. A good idea is to use a Sharpie to coat the commutator’s surface. This will enable you to see where the high spots are after the first lathe pass. You will also be able to tell when the commutator is straight and true.
- Begin turning and cutting the motor on the lathe. Cut just a little at a time by adjusting the lathe to cut in increments of one. Begin at the top of the commutator and cut in the direction of the inside of the motor. Go back and forth on the same setting a full time prior to turning the knob to cut more off the commutator. Once it is round again, use the X-Acto knife and run it between the grooves to rid the area of debris.
- Put the armature back in the can of the motor. The screws of the motor must be tight. Put it together that way it was before it was taken apart.
- Solder the new brushes on the end bell. Do this with a pair of pliers that will hold the tip of the wire lead in place. This will prevent the solder from making the wire stiff.
- Put the brushes in the brush hood. The hood is the area of the end bell where brushes slide in. Reinstall the springs on the brush hoods.
- Break in the motor by joining it to a two or three volt power source. Let it run for 10 minutes so the brushes will be back into place.