How to Remodel Sliding Windows

Sliding windows open by using two fabric belt that slide past one another. Remodeling sliding windows is a little different from the ordinary window installation.  Sliding windows are normally used in window fames where the width is greater than the height of the spacing.  This kind of window brings style and elegances to your home and they are easy to replace or remodel.

1. Locate the width and the height of the window frame. Use a tape measure for this stage. Buy a new window before you remove the old window. It will help you know if the new fit consistent with the frame size of the old installed one. Intend to match the thickness of the old window, however, it is not required.


2. Twist the lock switch on the window so that it is not in locked point. Tug the two windows out of the frame. Use a large flat head screwdriver to bend the upper part. The lower part and sides of the frame’s back can be bent if needed. Get rid of the window bits, and save them for a future task or throw them away.


3. Take off the screws that keep the window frame in place using a non-electric drill. Slip the flat head screwdriver between the frame and the wall. It will allow you to break through any old caulking, then, tear the window frame out. Remove the old silicone, caulk and weather stripping off by scraping with a putty knife.


4. Chop the tip of a tube of caulk off at an angle using scissors. It can be 1/4 to 1/2 inch. Put the tube into the caulking gun. Tip the tube facing downward. Then, squeeze the trigger until the caulk starts to come out. Grip the caulk gun up to the innermost frame of the window and use the clear silicone. Employ two or three beads among the width of each side of the innermost part of the frame. One bead should be put on the inside, outside and center. It guarantees the window will be draft free and will minimize heat loss from the home.


5. Move smoothly the new window into place. Join it into the just used silicone. Hold a little portion of cardboard across the new window frame. Tap the frame lightly with a hammer until the outermost edges of the border are evenly matched with the edges of the house window frame. Then, tap the window frame from the other side, if you tapped it too much. Do this promptly to ensure the silicone can start to set within 10 minutes.


6. Include brand new screws in each hole of the new window frame. Make sure they reach the framing of the house by using an electric drill and bit. Put in the screws securely.  Do not let screws stick out of the windows and frames because it will not be able to slide. Use a wet cloth to clean off the excess silicone caulk from the wall and window frame before it dries.