How to Remove Built in Bathtubs
Some bathrooms are small and in order to remove the bathtub from the bathroom you might have to take the toliet and the vanity out of the bathroom before starting this project. Make sure that you measure the door opening to find out whether the bathtub can fit through the door. It might be best to take the bathtub out through a room behind the bathtub.
Items needed:
- Pipe wrench
- Drain basket removal wrench
- Screwdriver
- Saw
- Gloves
- Safety glasses, or googles
- Sledge hammer
- 1 inch x 4 inch boards
Instructions:
- Turn off the water supply to the bathroom before starting the job. Find the access panel, if it is not in plain sight. Check the wall of the room or the closet right behind the plumbing. It might be in the basement or garage. Worst case, you have to cut a hole in the wall to turn off the water. Drain the water lines by letting all of the water run out of the pipes after turning off the water.
- Unscrew the water connections from the water pipes and unscrew the drain pipes so that the drain can be removed.
- Remove the drain with a drain basket removal wrench and remove the overflow pipe by turning the screw with a pipe wrench.
- Twist the spout counterclockwise with your hands to remove it from the tub. Unscrew the screws on the faucets handles and pull them off.
- Gently pry around the bathtub surround with a pry bar so that you can unscrew the bathtub. You may have to cut some sections of the wall in order to remove the tub.
- Slide the pry bar under the front edge of the bathtub and slide a couple of 1 inch x 4 inch boards underneath the tub to help keep the floor from being torn when you pull the tub from the wall. Get help to carry the bathtub out of the bathroom.