Previous Article

Cheap Flooring Tools

Next Article

Electric Tankless Water Heater Installation

How to Remove Cork Floor Tiles

Cork floor adhesive is usually used to install cork floor tile. Tile that is installed this way is much harder to remove as well as tile held down with nails. Cork tiles not installed with nails or glue is called a floating floor and they are the easiest to remove.

How to Remove Cork Floor Tiles


Materials Needed



  • Knife

  • Chisel

  • Hammer



  1. Use a knife to cut across the cork floor tile in either a horizontal or vertical direction. Place a chisel directly under the tile from where you placed the slit in the tile. Push the chisel as far as possible under the tile.

  2. Hit the handle of the chisel with a hammer to loosen the tile from the floor. If you notice the tile start to crack, stop and pull the chisel about two inches from under the tile. Hit the chisel handle with the hammer.

  3. Move the chisel down the slit in the tile and hit the handle with the hammer until the tile has been loosened from the floor. Pry up the tile with the chisel and remove the tile. Now work down the other half of the tile and remove it.

  4. Repeat all of the above steps for each piece of ceramic floor tile you want to remove from the subfloor. If you are only removing a few pieces of tile for replacement, use care when handling the chisel and hammer so you do not damage the surrounding tile.

  5. Fill a bucket with water and a few drops of liquid dish soap. Use a mop and the cleaning solution to clean the area. Rinse the area with clean water and allow it to dry.