Previous Article

How to Install a Mirror on an Oldsmobile Cutlass Supreme

Next Article

How to Remove an Oldsmobile Cutlass Driveshaft

How to Remove a Wiper From an Oldsmobile Cutlass

Changing wind shield wiper blades or arms are just one of many maintanence jobs a car owner faces.  Changing wiper blades and arms is fairly simple for any car owner reguiring only a few minutes of your time.  Windshield wiper blades can be changed at home or in the store parking lot.

Windshield wiper blades should be inspected and replaced on a regular basis to prevent damage to your windshield wiper glass and for adequate visibility while driving.  Before you begin, determine if the original wiper blade arms have been replaced.  A small flat head screw driver may be needed to release the small pin connector.  It is always beneficial to consult the manufacturer directions when starting any project.


Instructions:



  1. Pull the wiper blade away from the vehicle windshield, gently.  Raise the windshield wiper arm into a vertical position.

  2. Place the frame of the wiper blade in a right angle.

  3. Locate the wiper frame's locking mechanism.  The locking mechanism can be found at the middle connection point where the arm latches onto the wiper frame.  Once located unlock the mechanism.

  4. Pull the frame off of the wiper arm by holding the Oldsmobile arm in one hand and the from with the other hand.

  5. Allow the tip of the windshield wiper to rest on the windshield glass. Be certain to place a thick rag, towel or sponge between the wiper and the glass for protection of the windshield glass. 

  6. Once the wipers have been replaced, test the windshield wiper system to ensure safety while driving.