How to Repair Sliding Glass Door Rollers
A sliding glass door on a shower is a great accessory to have, except when the door starts to show signs of needing repairs. The most common problem that people have with this type of shower door is it falling off of its rollers. There is no need to purchase a new door because it can be repaired with the right tools.
How to Repair Sliding Glass Door Rollers
- Remove the door panel from the tracks. The door is much heavier than it looks, so ask for help. Use a small Phillips screwdriver and remove the screws holding the door. The screws are located in the small roller adjustments holes at the bottom of the shower door. Once the screws are taken out, lower the door and lean it forward and then lift it up and swing the bottom of the door out.
- Lay the door on its side and find the roller adjustment hole. Directly above this hole is another hole, which has a roller screw in it. Use a Phillips screwdriver to remove the screw and pry out the old roller.
- Take the old roller with you to your local home improvement store to purchase a new roller. It is very important that you purchase the same exact roller. Have the store clerk to help you find the right roller if you have any doubts about your selection.
- Insert the new roller back into the door and replace the screws. Flip the door over and continue on to do the other side.
- Use an old toothbrush and a paper towel to clean the tracks before reinstalling the door.
- Put the door back on the tracks by placing the top of the door in first and then swing the bottom into place.
- Use the Phillips screwdriver to adjust the new rollers. Slide the door to the closed position and make sure it is parallel to the frame.