How to Repair a Lawn Irrigation Line
Irrigation systems are a wonderful addition to your home landscape. Installed properly they can greatly enhance the appearance and value of your home. When one of the lines or heads in your lawn irrigation system is not working properly or broken it should be repaired immediately. This is of major importance if the line does not have a shut off to stop the water flow quickly.
- Determine what is causing the wet area first. It could be nothing more than an overlap of two or more heads. A simple re-aiming of the heads involved will solve the problem.
- Check to see if the leak is due to a faulty or worn out zone control valve. They are much like faucets and they can wear out as well. An easy way is to shut off the zone and check to see if it is still leaking water.
- Prior to replacing the zone control valve make certain it doesn’t just have some dirt or debris preventing it from completely closing. This particular step should be done be someone who knows sprinkler systems such as a professional.
- Make sure the leak is not due to low head drainage either. Simply put this is where the lowest head or two are draining out the water in that zone from gravity. This can be cured by adjustments and if not by installing a drain check valve in that line.
- Fix the last two problems; they are very similar in nature but one is immediately noticeable and the other only presents itself when the system is activated. Those would be leaks in the Main Line (constant water pressure all the time) and a zone leak (leaks only when the zone is on and running).
- Stop the main line leak as it is of top priority. It is under steady pressure as is every faucet in your home. You must shut off the water to the system immediately. All systems should be on a separate line dedicated to irrigation only.
- Fixing both the main and zone lines require the same repairs. Locate the break in the line and dig out the area. Cut the pipe with a hacksaw or similar device and install what is known as an inline coupler. This device slides over the two ends of the cut you made and is glued on. It will snap into position once the water is turned back on again. Do not cover your repaired section until you make certain it is no longer leaking water.