Previous Article

How to Change the Oil in a Dodge Ram

Next Article

How to Install Dodge Ram Brakes

How to Replace a Dodge Ram Track Bar

Replacing the Dodge Ram track bar is easily to do with some knowhow and will improve the suspension of the truck, especially because the Dodge Rams do not have the best suspension. Track bards keep the front axle of the truck center on the truck’s frame.

Items Needed:



  • Socket and Ratchet

  • Penetrating Fluid

  • Pliers

  • Grease Gun


 



  1. Set up the wheels of the Dodge Ram to point them straight forward and keep the steering wheel centered. Put down the parking brake.

  2. Spray the bolts on the factory track bar with penetrating fluid. Let the fluid sit on there for roughly 15 minutes. This will allow the bolts to be removed easily.

  3. Remove the pins on the two 18mm bolts. Use a ratchet and socket to loosen the bolts and remove them. Remove the factory track bar.

  4. Put the new track bar in the frame. Put one 18mm bolt through the bracket and track bar. Tighten with your hands.

  5. Put the adjustable end of the track bar to the tubing by threading it. Take the end of the track bar and hold up to the bracket. Line it up with the holes with the track bar.

  6. Place the track bar into the axle housing and put the 18mm bolt through the hole. Put the tab nut on the backside and tighten the bolt with a socket. Tighten all bolts as much as possible.

  7. Using the grease gun, brush the bolts with a little grease.

  8. Slide the new pins that came with the track bar onto the bolts. Bend the end of the pins slightly to stop them from moving around.