How to Replace a Garden Tractor Tire
You may find yourself with a tractor tire that has gone bad and in need of replacing it. You may not have the money to take it to a shop to get replaced so doing it yourself is a better route for you to go.
Things you need:
- Thick screwdrivers
- Air pump or compressor
- Soapy water in spray bottle
- Jack
- Lug nut screw
- Three tire irons
Instructions:
- Make sure the garden tractor is in park.
- Place the jack under the tire and lift the tire off the ground.
- Remove the lug nuts with the screw and you can remove the tire off the tractor.
- Get the new tire and let the air out of it. To accomplish this you will need to uncap the valve and hold it down and the air will start leaking out.
- Push the tire down close to the rim as possible and break the bead. You can also lay the wheel on a solid piece of ground and put a ramp down with one end on the tire next to the rim. Get in your car and slowly drive up the ramp that's in place until it pops the tire down and breaks the bead.
- Remove the top bead. Get the two tire irons ready. Place one iron on the top of the rim and the other under the tire.Place the third iron a few inches from one of the other tire irons, lever it up and over the rim. Repeat prying up small sections until the bead is free.
- Remove the bottom bead. Use the same technique and pry away the bottom bead away from the tire.
- Get the soapy water in the spray bottle and clean the rim. Remove all the gunk off the rim. Sspray the rim and the new tire beads.
- Put the new tire over the wheel and push down. This provides enough pressure to mount the tire onto the rim.
- Get the air pump or compressor and fill the tire up with air. When filling up the tire don't stop until you hear two loud pops, this sound will ensure you that the beads are set into place. Be careful not to overinflate the tire.
- Lower the tractor with the jack back to the ground and remove the jack from under the tractor.
- Test out the new tire.