Previous Article

How to Make a Helicopter Out of Paper and Cardboard

Next Article

How to Set Up a Remote Control Helicopter

How to Replace a Mini Helicopter Main Rotor

Mini helicopters can be purchased ready-to-use from the store or built using model and engine kits. No matter how the helicopter is made, it may need to have certain parts replaced. One of the most common parts to replace is the main rotor.

Items Needed:



  • Pliers

  • Hobby knife

  • New rotor blade

  • Model glue



  1. Use the pliers to hold the bolt in place. Hold underneath the rotor so the blade can move freely.

  2. Pull the rotor straight up away from the bolt to remove it from the bolt. Some helicopter models may require you to twist the rotor the opposite way it spins to remove it. Others will require you to cut around the edge of the rotor with a hobby knife to remove the plastic rotor from the bolt.

  3. Place the new rotor onto the bolt. The new rotor will have a small center hole that will fit around the bolt. Place it firmly against the top of the helicopter. Use the pliers to hold the bolt in place while you fit the rotor on it. Depending on the model of your helicopter, you may need to twist the rotor onto the bolt.

  4. Remove the pliers from the bolt and allow the main rotor to fall in place. Check that the rotor has the proper clearance by spinning it with your finger. If it spins freely, it has been installed correctly. If it sticks to the bolt or hits parts of the helicopter, it needs to be positioned higher on the bolt. Arrange the rotor blade as often as necessary to find its correct position.